osal_snv_read and osal_snv_write on BLE112 (CC2540 - 128kb version)

osal_svn_read and osal_snv_write provides a way for applications to store information into device's memory persistently.

Please refer to OSAL API pdf. There is a range of ID's which can be used for your applications to store data in. Others are reserved or used by the stack or ble platform.

Usable ID's are in range:

0x80 - 0xFE

When you run this code on BLE112 (or other cc2540 128kb version):

uint8 array[]={0,1,2,3,4,5,6,7,8,9};

uint8 read_array[10];

uint8_t result = osal_snv_write(0x80,6,array);

You will receive NV_OPER_FAILED in result. Same result when trying to read using osal_snv_read.

After some digging around net I found explanation. Code provided in sample applications (ie. SimpleBLEPeripheral) and HAL subsystem was designed to run on 256kb chip.

One file need to be fixed to use osal_snv read/write functions properly.

Search for hal_board_cfg.h file, look for code shown below:

// NV page definitions must coincide with segment declaration in project *.xcl file.

#if defined NON_BANKED

#define HAL_NV_PAGE_END                30

#elif defined HAL_BOARD_CC2541S

#define HAL_NV_PAGE_END                125

#else

#define HAL_NV_PAGE_END                126

#endif

change it to :

// NV page definitions must coincide with segment declaration in project *.xcl file.

#if defined NON_BANKED

#define HAL_NV_PAGE_END                30

#elif defined HAL_BOARD_CC2541S

#define HAL_NV_PAGE_END                125

#elif defined HAL_BOARD_128K

#define HAL_NV_PAGE_END                62

#else

#define HAL_NV_PAGE_END                126

#endif

and add HAL_BOARD_128K to your preprocessor settings: